Asha Enterprises

We offer Original MANIK MEK make Ammonia Controls as listed below for Industrial Ammonia Refrigeration applications.
Type SA5 solenoid valve is the direct acting type & type SA 17, SA 32, SA 42, SA 50 are higher capacity pilot operated solenoid valves for refrigeration & air conditioning applications. SPECIFICATIONS :
•             Refrigerants : R717 (NH3), R22, R134A etc.
•             Temperature of medium -40°C to + 80°C
•             Single coil (type KC -3) for all SA series valves.
TYPE MS SERIES
These high quality valves are compact, strong and reliable. Stainless steel pistons with Teflon seals are used to overcome the problem of valve sticking due to dirt or lack of oil. Pilot seats are polished stainless steel on Teflon discs and main valve seats align for tight closing. These valves can be used in liquid. suction, hot gas, discharge, pump lines etc., where a strong opening, tight closing valve is required.
FEATURES :
•  All Valves are spring closing.
•  All Valves have Teflon seat. One Solenoid Coil fits all Valves
Our Valves are suitable for Hansen, Parker, Danfoss, Manik, Castle, Henry etc. brands.

The Liquid Level Controllers are available in 2 models.

Type LC 101 AI & 39FI

The Liquid Controller consists of a float chamber and an electronic controller. It can be used on all non corrosive liquids such as Ammonia, Toluene, Freon etc.

The electronic controller has a bar graph display module installed to continuously display the rising & falling of liquid level inside the float chamber. The level controller is used to control the liquid level in various refrigeration applications.

These level controllers can also be used as a protection against too high & too low liquid levels.

SPECIFICATIONS :

•  Refrigerant R717 (NH3), HFC, HCFC.

•  Differential Adjustable between 10 to 40 mm.

•  Max operating pressure for float housing 19 bar.

•  Enclosure for float housing IP 65

•  Amplifier /  controller is  available in  IP  65  wall mounting enclosure or DIN 1/4 for panel mounting enclosure.

•  Float Chamber and Amplifier are also available in flame proof enclosure.

Application

• While primarily designed for Ammonia, this control is also suitable for R-22 and other non-corrosive liquids that have a specific gravity of 0.5 or more.
• The controller is ideal for the control of the operating level of liquid in liquid refrigerant accumulators and separators. Although this is normally done with a solenoid valve, the controller can activate an alarm or a pump or similar device.

Construction

• This device consists of two separate units, the float chamber and the electronic controller. The float chamber consists of a housing, float ball, float coil and coil enclosure. The float ball is located inside the housing and moves an attached magnetic stem up or down in an enclosing tube from the top and is protected by the coil enclosure. The construction permits all high voltage connections and wiring to be made at a remote or non-hazardous location.

Installation

These valves must be installed in horizontal ponecoll housing no more than

45 degrees from the vertical position.

Construction

The valveis made upfrom various metals.

Stainless steel is used for components like stem, plungers, themainbody ismade from LCC